Themis RES-12XR3, Руководство по установке

Страница: 83 / 146

3-15
Themis Computer
3—BIOS Setup Utility
Advanced Setup Configurations
SATA#2 Configuration (Available when the option-IDE is select-
ed.)
Selecting Enhanced will set SATA#2 to native SATA mode. The options are Dis-
abled, and
Enhanced (default).
3.3.5.2 IDE Detect Timeout (sec)
Use this feature to set the time-out value for the BIOS to detect the ATA, ATAPI
devices installed in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30, and
35
(default).
3.3.5.3 Primary IDE Master/Slave, Secondary IDE Master/Slave, Third
IDE Master, and Fourth IDE Master
These settings allow the user to set the parameters of the Primary IDE Master/Slave,
Secondary IDE Master/Slave, Third and Fourth IDE Master slots. Press <enter> to
activate the following submenu screen for detailed options of these items. Set the
correct configurations accordingly. The items included in the submenu are:
Type
Use this item to select the type of device connected to the system. The options are
Not Installed,
Auto (default), CD/DVD and ARMD
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a storage drive.
In the LBA mode, the maximum dive capacity is 137 GB. For drive capacities over
137 GB, your system must be equipped with a 48-bit LBA mode addressing support.
If not, install a ATA/133 IDE controller card that supports 48-bit LBA mode. The
options are disabled and
Auto (default)
Block (Multi-Sector Transfer)
Block Mode boosts the IDE drive performance by increasing the amount of data
transferred. Only 512 bytes of data can be transferred per interrupt if Block Mode is
not used. Block Mode allows transfers of up to 64 KB per interrupt. Select Disabled
to allow data to be transferred from and to the device on e sector at a time. Select
Auto to allow data transfer from and to the device occur multiple sectors at a time if
the device supports it. The options are
Auto (default) and Disabled.