Themis RES-12XR3, Руководство по установке

Страница: 36 / 146

RES-12XR3 Installation Manual - Configuration 7 Version 1.1
1-8
Themis Computer
1.5 Super I/O
The Super I/O supports two high-speed,16550 compatible serial communication
ports (UARTs). Each UART includes a 16-byte send/receive FIFO, a programmable
baud rate generator, complete modem control capability and a processor interrupt
system. Both UARTs provide legacy speed with baud rate of up to 115.2 Kbps as
well as an advanced speed with baud rates of 250 K, 500 K, or 1 Mb/s, which sup-
port higher speed modems.
The Super I/O provides functions that comply with ACPI (Advanced Configuration
and Power Interface), which includes support of legacy and ACPI power manage-
ment through an SMI or SCI function pin. It also features auto power management to
reduce power consumption.
1.5.1 Overview of the Winbond WPCM450 Controller
The Winbond WPCM450 Controller is a Baseboard management Controller (BMC)
that supports the 2D/VGA-compatible Graphics Core with the PCI interface, Virtual
media, and keyboard/Video/Mouse Redirection (KVMR) modules. With blade-ori-
ented Super I/O capability built-in, the WPCM450 Controller is ideal for legacy-
reduced server platforms.
The WPCM450 interfaces with the host system via a PCI interface to communicate
with the Graphics core. It supports USB 2.0 and 1.1 for remote keyboard/mouse/vir-
tual media emulation. It also provides LPC interface to control Super I/O functions.
The WPCM450 is connected to the network via n external Ethernet PHY module.
The WPCM450 communicates with onboard components via six SMBus interfaces,
fan control, and Platform Environment Control Interface (PECI) buses.
1.6 System LEDs and I/O Connectors
All RES-12XR3 system LEDs are located on the front panel (see A , Figure 1-5 ,
page 1-9); all I/O connectors are located on the rear panel (see B , Figure 1-5 ). LEDs
are described in Table 1-4 on page 1-11; I/O connectors are described in Table 1-5 ,
page 1-12.
Note: For more information on IPMI configuration, please refer to the Embedded
IPMI User’s Guide posted @ http://www.supermicro.com/support/manuals/