80
N2100 Simple Diagnosis Flowchart
This flowchart is meant to provide a simple and quick procedure to identify which
part of the N2100 has failed.
Procedure:
1. Don’t insert any HDDs into the N2100 system. Attach the power cord and then
reset the IP address and admin password to the default settings.
a) Power on the N2100 and immediately press the Reset button for 10 seconds.
b) This resets the N2100 to its default IP address and password settings.
Default IP: 192.168.1.100
Default admin password: admin
1.
The reset button is near the LAN connector.
2. Attach the power cord and connect the LAN cable between the N2100 and a PC.
Don’t use a hub.
3. Turn on the N2100 and check the front panel. The power LED should glow blue
after power button is pressed. Then, the Busy LED starts blinking orange for
around 60 seconds. After that, the busy LED turns off. If the busy LED keeps
blinking orange for more than 3 minutes, the firmware may be corrupted during
Содержание Y.E.S. Box N2100
Страница 1: ...Y E S Box N2100 Your Enhanced Storage User s Manual...
Страница 14: ...10...