Chapter 2: Getting Started
Overview
Your N299 is designed for complete ease-of-use. To help you get started, the
following chapter will help you get your N299 up and running in no time. Please
read it carefully to prevent damaging your unit during installation.
Before You Begin
Before you begin, be sure to take the following precautions:
1.
Read and understand the Safety Warnings outlined in the beginning of
the manual.
2.
If possible, wear an anti-static wrist strap during installation to prevent
static discharge from damaging the sensitive electronic components on the
N299.
3.
Be careful not to use magnetized screwdrivers around the N299’s
electronic components.
4.
The N299 uses its chassis to dissipate heat. Please leave your N299 in a
well-ventilated area to prevent overheating.
Hard Disk Installation
The N299 supports standard 3.5” (SATA) hard disks. To install a hard disk into
the N299, follow the steps below:
1.
Remove two screws located on the back of the unit using a Philips
screwdriver.
2.
Unscrew four mounting screws.
3.
Lift up the hard disk tray by pulling up the top panel of the N299.
4.
Carefully insert a standard 3.5” SATA hard disk into the tray, and secure
the hard disk with screws from the included accessory pack.
5.
If you are installing two hard disks, please insert the second hard disk at
the bottom of the tray and secure it with screws from the included
accessory pack.
6.
Carefully lower the hard disk tray back into the N299.
7.
After making sure the tray is in place and the connectors are aligned,
secure the hard disk tray with screws.
NOTE
If your hard disk was previously part of a RAID 1 array, it will automatically rebuild.
If you replace all the drives with higher capacity drives, you need to go to the
Administrator login and format the drives.
12
Содержание N299
Страница 1: ...Thecus N299 User s Manual ...
