Theben theLuxa S360 WH, Руководство пользователя

Страница: 2 / 4

2
† †
Make marks for the holes on the wall (with en-closed drill
template/base).
† †
Drill holes.
Ø 6 mm
60mm
† †
Feed cable through the seal of the base.
† †
Fasten base (and spacer frame) to the wall.
OR
brown
brown
Phase
Switched
phase
Neutral
conductor
Neutral
conductor
Earthing
conductor
Earthing
conductor
blue
blue
green/yellow
† †
Connect the individual wires to the appropriate terminal.
† †
Tighten screws.
Click! Click!
† †
Plug motion detector into base and click in.
† †
† †
Connect motion detector to power supply.
Dismantling
† †
Using the screwdriver, carefully loosen the snap-in hook at
the side and pull the device forward.
Installation instructions
As the detector reacts to variations in temperature, avoid the
following situations:
† †
Do not direct motion detectors at objects with highly reflec-
tive surfaces such as mirrors etc.
† †
Do not install motion detectors near heat sources such as
heating outlets, air conditioning systems, lamps etc.
† †
Do not direct the motion detector at objects that turn in the
wind such as curtains, large plants etc.
† †
Take account of motion direction during test run.
10
20
30
40
40
10
20
30
40
40
10
20
30
40
40
5 m
16 m
360°
•
Recommended installation height: 2 – 4 m
•
Crosswise detection area: 16 m (crosswise to the detector)
•
Frontal detection area: 5 m (in front of the detector)
•
Detection angle: 360°
5. Direction test and alignment
The walk test is used to test the detection range and to res-
trict it if necessary.
† †
Set the potentiometer time (min) to test.
The motion detector now only reacts to movement (indepen-
dent of brightness).
† †
Crosswise to the detection area. After the motion detector
has detected a movement, it switches on for 2 s.
Note direction of motion during the test.