1
theLeda D S AL
1020901
theLeda D SU AL
1020902
theLeda D U AL
1020903
theLeda D UD AL
1020904
307397 02
LED lamp
with motion detector
EN
1. Basic safety information
!
Only intended for installation out of arm's reach.
!
High temperature! Do not touch the metal parts of the
device.
L
The LED lamp with motion detector (PIR) conforms to EN
60598-1 if correctly installed.
2. Proper use
•
Device is intended for wall mounting outdoors
•
For entrances, single-family houses, building fronts, hotel
entrances, medical practices, etc.
•
For use in normal ambient conditions
•
The LED lamp is used for lighting, depending on pre-
sence and brightness
•
Operable with theSenda S remote control, adjustable
with theSenda P and theSenda B with theSenda Plug app
L
Lamp cannot be replaced.
Replace entire lamp if defective!
Disposal
Dispose of LED lamp properly (electronic waste)
3. Connection
Danger of death through electric shock or fire!
¾
Installation should only be carried out by a
qualified electrician!
WARNING
Disconnect power source!
Ensure device cannot be switched on!
Check absence of voltage!
Earth and bypass!
Cover or shield any adjacent live components.
Connecting the LED lamp
N
L
N
L
N
L
N
L
E
4. Installation
L
If wireless networking of several devices is desired, a
wireless channel can be selected on the rear of the device
before installation. To do this, the same wireless channel
(1–6) must be set for all devices of one group. If the func-
tion is not required, switch off wireless (off).
L
Suitable for surface-mounted installation
L
Optionally mountable with corner bracket 9070970, spacer
frame 9070972
L
Observe the recommended installation height of 1.8 m -
2.2 m!
4 m
10 m
2 m
4 m
Installation instructions
As the integrated motion detector responds to variations in
temperature, avoid the following situations:
Do not direct the motion detector (PIR) of the LED lamp at
objects with highly-reflective surfaces
Do not install the motion detector near heat sources, such
as heating outlets, air conditioning systems, lamps, etc.
Do not direct the motion detector at objects that move in
the wind, such as large plants, etc.
Pay attention to the typical direction of motion during the
test run
L
If you walk diagonally to the motion detector, the detec-
tion is more sensitive than with a direction of movement
directly towards the motion detector.