Textron JACOBSEN GP400, Техническое руководство по ремонту

Страница: 248 / 354

6-56 4252490-Rev A
HYDRAULICS
6
Figure 6-69
3. Remove piston rod assembly (6) from barrel (5).
Figure 6-70
4. Remove seals (7 and 8) from piston (9).
!
WARNING
NOTICE
5. Clean all parts using clean solvent, and dry using
compressed air.
6. Inspect all parts for excessive wear, cracks, broken
parts, and scoring of the cylinder barrel, piston, and
rod.
7. Inspect the barrel for dents, score lines, or grooves
inside.
8. Inspect the fittings for wear and damage.
Assembly Notes
NOTICE
• Use a new seal kit during assembly.
• Lubricate O-rings, rod seal, and wiper with clean
hydraulic oil before assembly.
• Assemble lift cylinder by reversing the order of
disassembly.
TN3829
6
5
TN3832
8
7
9
Use appropriate eye protection when using
compressed air for cleaning or drying purposes.
Compressed air can cause serious personal
injury. Use safety reduction valves to reduce the
air pressure to a safe level before use.
During repair of the cylinder, use extreme care
not to damage the barrel, piston, rod, and sealing
surfaces of the cylinder.
It is important that all component parts are
absolutely clean, as contamination can result in
serious damage and/or improper operation.
Never use shop towels or rags to dry parts after
cleaning, as lint may clog passages. Dry parts
using compressed air.
It is important that all component parts are
absolutely clean, as contamination can result in
serious damage and/or improper operation.
Never use shop towels or rags to dry parts after
cleaning, as lint may clog passages. Dry parts
using compressed air.
Required Materials
Seal Kit