TEXIO LSG SERIES, Инструкция по эксплуатации

Страница: 49 / 167

37
2-2. Basic Configuration
The basic configuration settings are the common configuration
settings that are used for each operating mode. After selecting a
basic operating mode (CC, CR, CV or CP mode), the slew rate,
switching mode, response rate and other common parameters should
be configured.
2-2-1. Select the Switching Function
Description The LSG Series has two switching modes, static
and dynamic. The switching modes allow the
LSG Series to switch between two preset levels.
Static mode can only switch between the two
levels manually, while Dynamic mode switches
between each level automatically based on a
timer.

Static mode: A Value, B Value

Dynamic mode: Level1, Level2
When the unit is set to static mode, only one
value (A Value or B Value) can be active at a
time. The active value is shown in the Operation
Status Panel.
Function
Static
Configure
0.00
w
LOAD RS232 SHORT
A Value
Fine
W
W
Active setting
When the unit is set to dynamic mode, the unit
will switch between Level1 and Level2 based on
the Timer1 and Timer2 parameters, shown
below.
Level
Time
Level 2
Level 1
Timer1 Timer2 Timer1
Dynamic Mode
Note
Dynamic mode is not available for CV mode.