TEXIO FGX-2220, Инструкция по эксплуатации

Страница: 212 / 229

199
-131 Invalid suffix
An invalid suffix was used. Example: An unknown or incorrect
suffix may have been used with a parameter.
SOURce1:SWEep:TIME 0.5 SECS
-138 Suffix not allowed
A suffix was used where none were expected. Example: Using
a suffix when not allowed.
SOURce1:BURSt: NCYCles 12 CYC
-148 Character data not allowed
A parameter was used in the command where not allowed.
Example: A discrete parameter was used where a numeric
parameter was expected.
SOUR1:MARK:FREQ ON
-158 String data not allowed
An unexpected character string was used where none were
expected. Example: A character string is used instead of a valid
parameter.
SOURce1:SWEep:SPACing ’TEN’
-161 Invalid block data
Invalid block data was received. Example: The number of bytes
sent with the DATA:DAC command doesn’t correlate to the
number of bytes specified in the block header.
-168 Block data not allowed
Block data was received where block data is not allowed.
Example:
SOURce1:BURSt: NCYCles #10
-170~178 expression errors
Example: The mathematical expression used was not valid.
8-21-2.Execution Errors
-211 Trigger ignored
A trigger was received but ignored. Example: Triggers will be
ignored until the function that can use a trigger is enabled
(burst, sweep, etc.).
-223 Too much data
Data was received that contained too much data. Example: An
arbitrary waveform with over 4096 points cannot be used.
-221 Settings conflict; turned off infinite burst to allow immediate trigger source
Example: Infinite burst is disabled when an immediate trigger
source is selected. Burst count set to 65535 cycles.
-221 Settings conflict; infinite burst changed trigger source to MANual
Example: The trigger source is changed to immediate from
manual when infinite burst mode is selected.
-221 Settings conflict; burst period increased to fit entire burst
Example: The function generator automatically increases the
burst period to allow for the burst count or frequency.