TEXIO FGX-2220, Инструкция по эксплуатации

Страница: 192 / 229

179
The following is an overview of the steps required to generate a burst waveform.
Enable Burst
Mode
Configuration
Choose
Triggered/Gated
Mode
Set Burst Count
Set the burst
period
Set Burst Starting
Phase
Select the trigger
1. Turn on Burst mode using the
SOURce[1|2]:BURS:STAT ON command.
2. Use the APPLy command to select a sine, square, ramp,
pulse burst waveform*. Alternatively, the FUNC, FREQ,
AMPl, and DCOffs commands can be used to create the
burst waveform* with a designated frequency, amplitude
and offset.
*2 mHz minimum for internally triggered bursts.
3. Use the SOURce[1|2]: BURS:MODE command to select
from triggered or gated burst modes.
4. Use the SOURce[1|2]:BURS:NCYC command to set the
burst count. This command is only for triggered burst
mode only.
5. Use the SOURce[1|2]:BURS:INT:PER command to set
the burst period/cycle. This command is only applicable
for triggered burst mode (internal trigger).
6. Use the SOURce[1|2]:BURS:PHAS command to set the
burst starting phase.
7. Use the SOURce[1|2]:BURS:TRIG:SOUR command to
select the trigger source for triggered burst mode only.
8-15-2. SOURce[1|2]:BURSt:STATe
Set
Query
Description Turns burst mode on or off. By default burst mode is turned
off.
Note When burst mode is turned on, sweep and any modulation
modes are disabled.
Syntax SOURce[1|2]:BURSt:STATe {OFF|ON}
Example SOUR1:BURS:STAT ON
Turns burst mode on.