TEXIO FGX-2220, Инструкция по эксплуатации

Страница: 216 / 229

203
-222 Data out of range; burst period limited by length of burst; value clipped to
upper limit
Example: The burst period must be greater than burst count
divided by the fre 200 ns. The burst period is adjusted
to satisfy these conditions.
burst period > 200 ns + (burst count/burst frequency).
-222 Data out of range; burst count limited by length of burst; value clipped to
lower limit
Example: The burst count must be less than burst period * the
waveform frequency when the the trigger source is set to
immediate (SOURce[1|2]: TRIG:SOUR IMM). The burst count is
automatically set to the lower limit.
-222 Data out of range;amplitude; value clipped to ...
Example: If the amplitude was set to a value out of range, it is
automatically set to an upper or lower limit.
-222 Data out of range;offset; value clipped to ...
Example: If the offset was set to a value out of range, it is
automatically set to an upper or lower limit.
-222 Data out of range;frequency in burst mode; value clipped to ...
Example: If the frequency was set to a value out of range in
burst mode. The burst frequency is automatically set to an
upper or lower limit, taking the burst period into account.
-222 Data out of range;frequency in FM; value clipped to ...
Example: The carrier frequency is limited by the frequency
deviation (SOURce[1|2]: FM:DEV). The carrier frequency is
automatically adjusted to be less than or equal to the frequency
deviation.
-222 Data out of range;marker confined to sweep span; value clipped to ...
Example: The marker frequency is set to a value outside the
start or stop frequencies. The marker frequency is automatically
adjusted to either the start or stop frequency (whichever is
closer to the set value).
-222 Data out of range;FM deviation; value clipped to ...
Example: The frequency deviation is outside of range. The
deviation is automatically adjusted to an upper or lower limit,
depending on the frequency.
-222 Data out of range;trigger delay; value clipped to upper limit
Example: The trigger delay was set to a value out of range. The
trigger delay has been adjusted to the maximum (655350
nseconds).
-222 Data out of range; trigger delay limited by length of burst; value clipped to
upper limit
Example: The trigger delay and the burst cycle time combined
must be less than the burst period.