TEXIO FGX-2220, Инструкция по эксплуатации

Страница: 185 / 229

172
8-14-2. SOURce[1|2]:SWEep:STATe
Set
Query
Description Sets or disables Sweep mode. By default Sweep is disabled.
Sweep modulation must be enabled before setting other
parameters.
Note Any modulation modes or Burst mode will be disabled if
sweep mode is enabled.
Syntax SOURce[1|2]:SWEep:STATe {OFF|ON}
Example SOUR1:SWE:STAT ON
Enables sweep mode.
Query Syntax SOURce[1|2]:SWEep:STATe?
Return Parameter 0 Disabled (OFF)
1 Enabled (ON)
Example SOUR1:SWE:STAT?
1
Sweep mode is currently enabled.
8-14-3. SOURce[1|2]:FREQuency:STARt
Set
Query
Description Sets the start frequency of the sweep. 100Hz is the default
start frequency.
Note To sweep up or down, set the stop frequency higher or lower
than the start frequency.
Syntax SOURce[1|2]:FREQuency:STARt
{<frequency>|MINimum|MAXimum}
Parameter <frequency>
1μHz~ 25MHz
1μHz~ 15MHz(Square)
1μHz~ 1MHz (Ramp)
Example SOUR1:FREQ:STAR +2.0000E+03
Sets the start frequency to 2kHz.
Query Syntax SOURce[1|2]:FREQuency:STARt? [MINimum|
MAXimum]
Return Parameter <NR3> Returns the start frequency in Hz.