TEXIO DL-1060, Инструкция по эксплуатации

Страница: 86 / 146

80
※
Note: The MEM annunciator will be lit while the multimeter stores readings and be
turned off when the specified number of readings is reached.
How to recall the stored readings
1. Press SHIFT + STORE buttons, and the multimeter will display all the stored
readings starting from the first reading. Use
◁
and
▷
buttons to move from the
first reading to the last reading the meter has stored as shown in Figure 3-33 .
Figure 3-33
Remote Interface Operation
You can use the following commands from the your PC terminal to store or retrieve
readings in the
memory
.
In addition, the number for STORE function only can be set
through front panel.
INITiate
(
This command tells the meter to be on “wait -for- trigger” state. After a
measurement is taken, measurement readings will be placed in the
memory.
)
FETCh?
(
Use this command to retrieve stored readings.
)
DATA:POINts?
(
Use this command to query the number of stored readings
.)
3.4.4 Sensitivity Band (Hold)
The reading hold function captures and holds a stable reading on the display. DL-1060
beeps and holds the value when it detects a stable reading. The sensitivity band in
reading hold decides which reading is stable enough. This band is expressed as a
percent of reading on the selected range. DL-1060 considers a reading stable when
three consecutive values are within the band. You have an option to adjust this
sensitivity band.