INS467-9 11/47
OFF = Ricochet
Switch 3 OFF = Impaq Contact-W Wired Input 2 will report as Tamper (default)
ON = input 2 will report as an Alarm.
Switch 4 Walk test
12: Address Switch
Used to assign the address of the receiver on the network
13: RF LED
Flashes when transmitting or receiving RF data
14: Tamper Disable
Disables the lid and rear tamper
15: Engineer’s Keypad LED's
Red LED flashes constantly, the flash rate increases when data is being
transmitted.
16: Flash Programming Port
Variant dependent, for flashing the expander with updated firmware.
4.1 Mounting the Expander
Remove each screw cap by inserting a flat bladed screwdriver into the slot and
turning anti-clockwise, excessive force is NOT required. Remove both of the cover
screws and put them in a safe place along with the screw caps. Gently pull the
cover away from the base applying slight pressure to the sides at the top of the
expander if required. The front cover should now be off.
Mount the expander using at least two appropriate countersunk screws (no larger
than No. 8). A keyhole slot has been provided to assist mounting and aid levelling.
