Texas Instruments Voyage 200, Руководство пользователя

Страница: 533 / 1008

Data/Matrix Editor 533
To turn Auto-calculate off and on from the Data/Matrix Editor:
If
Auto-calculate = OFF
and you make changes as described above, the header
definitions are not recalculated until you set
Auto-calculate = ON
.
Note:
You may want to set
Auto-calculate = OFF
to make changes without recalculating
each time, enter a definition such as c1=c2+c3 before you enter columns 2 and 3, or
override any errors in a definition until you can debug the error.
Using Shift and CumSum Functions in a Column Using Shift and CumSum Functions in a Column Using Shift and CumSum Functions in a Column Using Shift and CumSum Functions in a Column
Header Header Header Header
When defining a column header, you can use the shift and
cumSum
functions as
described below. These descriptions differ slightly from the Technical Reference module.
This section describes how to use the functions in the Data/Matrix Editor. The Technical
Reference module gives a more general description for the Home screen or a program.
1. Press:
ƒ
9
– or –
8
F
2. Change
Auto-Calculate
to
OFF
or
ON
.
3. Press
¸
to close the dialog box.