Test Summary
8
SLLU282A – December 2017 – Revised February 2018
Copyright © 2017–2018, Texas Instruments Incorporated
UCC5390SCD With Isolated Bias Supply
5
Test Summary
5.1
Definitions
This test procedure details how to configure the test setup and capture key waveforms of the
UCC5390SCDEVM-010 boards when they operate in power system as part of a high voltage buck
converter.
5.2
Before You Begin
The following warnings and cautions are noted for the safety of anyone using or working close to the
UCC53x0 EVM. Observe all safety precautions.
CAUTION:
Caution! Warning: Hot surface contact may cause burns. Do not touch.
HOT SURFACE:
Precautions when operating.
HIGH VOLTAGE:
Danger: High voltage! The UCC53x0 device has an isolation boundary, but does not have safety
rated reinforced isolation. If you apply high voltage to this board, all terminals should be
considered high voltage. Electric shock is possible when connecting the board to live wire.
The board should be handled with care by a professional. For safety, TI highly recommends use
of isolated test equipment with overvoltage and overcurrent protection.
CAUTION
❏
Do not leave the EVM unattended while powered.
❏
All high voltage, high temperature, and hazard safety rules, applied to the
power system where these EVMs are embedded for bench evaluation, must
be strictly followed.