Host
Computer
USB Cable
USB
Interface
Adapter
Green LED
Indicates
Power
10-Pin
Ribbon
Cable
EVM Board
Figure 5-2. USB Interface Adapter Quick Connection Diagram
5.4 Installing Software
If installing from the TI Web site, go to
Note:
This installation page is best viewed with the Microsoft
®
Internet Explorer
®
browser (It may not work
correctly with other browsers)
Click on the install button; your PC should give you a security warning and ask if you want to install this
application. Select Install to proceed. If a pre-release or Beta version is currently installed on your PC, you must
uninstall this version of the software before installing the final version.
To run the software after installation, go to Start → All programs → Texas Instruments → TPS65279V EVM
Software.
At start-up, the software first checks the firmware version of the USB-TO-GPIO adapter box. If an incorrect
firmware version is installed, the software automatically searches on the internet (if connected) for updates. If a
new update is available, the software gives notification of the update, and downloads and installs the software.
Note that after the firmware is updated the USB cable between the adapter and PC must be disconnected and
then reconnected, as instructed during the install process. The host PC software also automatically searches on
the internet (if connected) for updates. If a new update is available, the software gives notification of the update
and downloads and installs it. During future use of the software, a prompt may be given to install a new version,
if one becomes available.
Note
VeriSign
®
Code Signing is used to prevent any malicious code from changing this application. If at any
time in the future the binaries are modified, the code will no longer attempt to run.
Bench Test Setup Conditions
10
TPS65279V Buck Converter Evaluation Module User's Guide
SLVU876A – FEBRUARY 2013 – REVISED MAY 2021
Copyright © 2021 Texas Instruments Incorporated
