Texas Instruments TPS2596, Руководство пользователя, Страница: 10 / 20

General Configurations
www.ti.com
10 SLVUBN7A – April 2019 – Revised August 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
TPS2596EVM: Evaluation Module for TPS2596xx
Figure 3. J4 = 3-4, Current Limit (1.0 A) Test Auto Retry (CH1)
4. Set the output load at 5.0
Ω
± 0.5
Ω
on CH2 and then enable the load. Turn on the VIN2 power supply
and verify that input/output current is limited as per the setting in Table 9 . Verify the device is in
latched-off mode and that the FLTb2 RED LED (D5) turns ON as shown in Figure 4 . The level of the
current pulse should match with the load current limit (based on the respective jumper setting) as
shown in
Table 9 .