LMT01 Setup and Operation
3
LMT01 Setup and Operation
3.1
Quickstart Guide
1. Connect the LMT01EVM to a USB port on a PC.
2. One red and one green LED should turn on and not blink when the EVM is initially plugged into the
PC. The red LED will blink if the power on reset tests on the MSP430 microcontroller fails on startup or
if the Test LED button is toggled. The green LED will blink when the Start Graph button is pressed.
3. Launch the LMT01EVM software by clicking on Start >> All Program >> Texas Instruments >>
LMT01EVM >> LMT01EVM. The LMT01EVM GUI should automatically connect to the appropriate
COM port. A successful connection will show “Connect Successful!” on the bottom of the GUI. If there
is a connection problem check in the Control Panel >> Device Manager >> Ports and verify if the
LMT01EVM has an established connection with the PC.
Figure 6. LMT01EVM Successful Connection with PC
7
SNIU027A – March 2015 – Revised October 2015
LMT01EVM
Copyright © 2015, Texas Instruments Incorporated
