Test Procedure and Results
8
SLVUBM3B – January 2019 – Revised December 2019
Copyright © 2019, Texas Instruments Incorporated
LM76202-Q1 Evaluation Module
Figure 5. LM76202-Q1EVM Output Hot Short (VIN = 12.5 V, ILIM = 2.23 A, MODE = RTN)
6.4
Overvoltage Cut-off Protection Test
Use the following instructions to perform output overvoltage protection test
•
Set the input supply voltage VIN to 36 V and current limit of 10 A and enable the power supply.
•
Connect a load of 28
Ω
(30 W) at connector T2 of the EVM.
•
Observe the waveforms of VIN, VOUT, FLT and IOUT using an oscilloscope.
shows an example of overvoltage cutoff protection on the LM76202-Q1EVM. FLT is pulled-up
from VIN for this test.
