Texas Instruments DVEVM, Руководство по началу работы, Страница: 20 / 70

Connecting to a Console Window
2-6
2.2 Connecting to a Console Window
You can open a console window that allows you to watch and interrupt
DVEVM boot messages by following these steps:
1) Connect a serial cable between the serial port on the DVEVM and the
serial (COM) port on a PC.
2) Run a HyperTerminal session on the PC and configure it to connect
to that serial port.
3) When you power on the DVEVM, you will see boot sequence
messages. You can press a key to interrupt the boot sequence and
type commands in the U-Boot command shell. In this guide,
commands to be typed in the U-Boot shell are indicated by an
EVM #
prompt.