Texas Instruments DLP DLPC7540, Руководство пользователя

Страница: 10 / 18

Figure 2-3. Command Interface Settings
c. Verify that EVM Status shown at bottom left of GUI says Connected, Bootloader Mode indicating you are
ready to load image file into EVM.
4. Flash Loader Configuration:
a. Go to Firmware screen, select Update Firmware tab. Click on the folder icon to browse for the applicable
firmware depending on the actual DMD that is connected to DLPC7540EVM. Once firmware image file is
selected, click on Start Update
Figure 2-4 .
b. Wait for the programming progress to indicate that firmware update is complete.
c. Turn off the EVM by toggling the SW1 and SW5 switches in that order to
off position. Remove the
jumper from J9 and install it back to J67.
d. Turn on the EVM by toggling the SW5 and SW1 switches in that order to on position. After about 3
seconds you should see D5, D6, and D7 LEDs steadily on and D15 LED flashing. The DLP Texas
Instruments logo should be visible on the DMD
Figure 2-5 .
Quick Start www.ti.com
10 DLP® Display DLPC7540 4K UHD EVM DLPU109 – MAY 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated