Jumper Setting
3-5
EVM Operation
3.3
Jumper Setting
Table 3 - 5 shows the function of each jumper on the EVM.
Table 3 - 5. Jumper Setting Functions
Reference
Setting
Function
1
3
R
OFFSET
is strapped to V
REF
to set V
SJ
(summing junction) to V
REF
/2. Refer to the
data sheet for offset adjustment.
W1
1
3
R
OFFSET
is not connected to set V
SJ
(summing junction) to V
REF
/3. Refer to the data
sheet for offset adjustment.
1
3
R
OFFSET
is strapped to AGND to set V
SJ
(summing junction) to V
REF
/6. Refer to the
data sheet for offset adjustment.
1
3
Disables the internal reference voltage.
W2
1
3
Enables the internal reference voltage of 10 V.
1
3
REFin is strapped to REFout to allow the internal 10 V to supply the DAC reference
voltage.
W3
1
3
REFin is strapped to exREFin to allow either the onboard adjustable reference or user
supplied reference to supply the DAC reference voltage.
1
3
Routes the onboard 10 V reference through the adjustable pot to W3.
W4
1
3
Routes the user supplied reference from TP1 or J4- 20 through the adjustable pot to
W3.
1
3
Negative supply rail of op amp is powered by V
SS
for bipolar operation.
W5
1
3
Negative supply rail of op amp is tied to AGND for unipolar operation.
REFadj pin is not connected.
W6
REFadj pin is connected to R1 pot for gain adjustment input when internal reference
is used.
RFB2 pin is not connected to the V
OUT
pin.
W7
RFB2 pin is strapped to the V
OUT
pin for feedback.
TEST pin not connected to DGND.
W8
TEST pin connected to DGND (default mode).
SJ (summing junction) pin of the DAC output amplifier is not connected.
W9
SJ (summing junction) pin of the DAC output amplifier is connected to R2 pot to allow
small amount of current for offset adjustment.
RFB1 pin is not connected.
W10
RFB1 pin is strapped to RFB2 pin for DAC V
OUT
feedback.
Legend:
Indicates the corresponding pins that are shorted or closed.
