Assembling System
8
SLOU515 – July 2019
Copyright © 2019, Texas Instruments Incorporated
DRV2625 Haptics BoosterPack™ Plug-In Module
Figure 7. LCD DRV26X Text
2.4.2
BOOSTXL-DRV2625 BoosterPack (Advanced).
The BoosterPack has a preconfigured and ready-to-use demo firmware. However, for cases where it is
required a different firmware for evaluation purposes or the demo firmware needs to be programmed
again, it is possible to configure it with the help of the MSP430 CapTIvate MCU Programmer and Code
Composer Studio.
See
MSP430 CapTIvate MCU Programmer Product Folder
for details about this tool.
For more details about the demo firmware programming, see Apendix A
.
3
Assembling System
The DRV2625 Haptics BoosterPack is designed to work with the MSP-EXP430FR6989 LaunchPad.
Before powering up, begin by assembling the two board system by aligning the 40 connectors on the
bottom of the DRV2625 Haptic BoosterPack to the 40 pins on top of the LaunchPad. Make sure you plug
in the J1 column connectors on the back of the DRV2625 Haptic BoosterPack to the J1 column pins on
the front of the MSP-EXP430FR6989 LaunchPad. This will align all pins. After aligning, plug the boards
into one another. Refer to
below for more details.
