![Texas Instruments Boomer LM49360 Скачать руководство пользователя страница 62](http://html1.mh-extra.com/html/texas-instruments/boomer-lm49360/boomer-lm49360_user-manual_1094195062.webp)
TABLE 19. THRES
Bank 0: CONFIG = Z (0x1Bh)
Bank 1: CONFIG = H (0x2Bh)
Bank 2: CONFIG = L (0x3Bh)
Bits
Field
Description
3:0
UVLO_VSEL
Input on PV
DD
.
The PVDD voltage level is monitored and if it falls below this value, the PMU will enter
into the STANDBY state.
UVLO_VSEL
PVDD (V)
UVLO_VSEL
PVDD (V)
0000
2.3
1000
2.7
0001
2.35
1001
2.75
0010
2.4
1010
2.8
0011
2.45
1011
2.85
0100
2.5
1100
2.9
0101
2.55
1101
2.95
0110
2.6
1110
3
0111
2.65
1111
3.05
5:4
TIMESTEP
TIMESTEP
Time per Step
(microseconds)
00
8
01
64
10
128
11
256
6
RESERVED
Reserved bit, this bit must remain cleared.
7
LDO7_PD
If set, the LDO7 output will be pulled down by a 300
Ω
resistor when the LDO is disabled,
speeding the discharge of attached decoupling capacitors.
TABLE 20. PLDWN
Bank 0: CONFIG = Z (0x1Ch)
Bank 1: CONFIG = H (0x2Ch)
Bank 2: CONFIG = L (0x3Ch)
Bits
Field
Description
0
BK1_PD
If set, the Buck1 output will be pulled down by a 300
Ω
resistor when disabled.
1
BK2_PD
If set, the Buck2 output will be pulled down by a 300
Ω
resistor when disabled.
2
LDO1_PD
If set, the LDO1 output will be pulled down by a 300
Ω
resistor when disabled.
3
LDO2_PD
If set, the LDO2 output will be pulled down by a 300
Ω
resistor when disabled.
4
LDO3_PD
If set, the LDO3 output will be pulled down by a 300
Ω
resistor when disabled.
5
LDO4_PD
If set, the LDO4 output will be pulled down by a 300
Ω
resistor when disabled.
6
LDO5_PD
If set, the LDO5 output will be pulled down by a 300
Ω
resistor when disabled.
7
LDO6_PD
If set, the LDO6 output will be pulled down by a 300
Ω
resistor when disabled.
TABLE 21. OVR
Bank 0: CONFIG = Z (0x1Dh)
Bank 1: CONFIG = H (0x2Dh)
Bank 2: CONFIG = L (0x3Dh)
This sets the Function of OVR pin mode. If all are zero only Buck2 is enabled by the pin (this pin always forces Buck2 on). Other
outputs can be set by setting the relevant bit here.
Bits
Field
Description
0
BK1_OVR
If set, the Buck 1 output is enabled when OVR is set.
1
LDO1_OVR
If set, the LDO 1 output is enabled when OVR is set.
2
LDO2_OVR
If set, the LDO 2 output is enabled when OVR is set.
3
LDO3_OVR
If set, the LDO 3 output is enabled when OVR is set.
61
www.ti.com
LM49360
Содержание Boomer LM49360
