Texas Instruments Avigo, Руководство пользователя

Страница: 123 / 132

12-8 Avigo User’s Guide
Synchronizing with Your PC
Synchronization allows you to update PC and Avigo entries so that no difference
exists between the entries at both locations. Changes made to entries on the PC will
be duplicated to entries on Avigo and vice versa.
There are two ways to synchronize your Avigo with your PC:
¦
Using the wired (Avigo dock station and PC serial port) method.
¦
Using the wireless (Infrared) method.
Note: Synchronization software on the PC may not support Infrared communication or
synchronization initiated from the Avigo organizer. For more information, refer to the
online documentation.
To use Wired (Serial Port) Synchronizing:
1. Set up the Avigo dock station on a flat surface near your PC ( Figure 1 ).
Figure 1 Figure 2
2. Connect the cable to the PC serial port you will use. If necessary, use a 9-pin-to-
25-pin adapter. Make sure that all the connectors are securely connected
(
Figure 2 ).
3. Position your Avigo over the dock station and begin
gently sliding it into the dock station. Make sure the
grooves on the right and left sides of Avigo engage the
alignment tracks in the dock station (
Figure 3 ).
4. Continue sliding Avigo into the dock station until the
electronic pins in the dock station are fully engaged in
Avigo.
5. Make sure that the appropriate PC software is running
on the PC. Refer to the PC software documentation for
instructions on synchronizing using that software.
Figure 3