Testing the EVM Data Capture With LVDS
13
SLOU430A – December 2015 – Revised February 2016
Copyright © 2015–2016, Texas Instruments Incorporated
AFE5818 16-Channel Analog Front End Evaluation Module (EVM Rev. C)
Figure 14. AFE_RST Hardware Reset Button
Figure 15. Software Reset Button
3. Press the
Initialize Device
button on the HMC-DAQ GUI. The progress bar indicates the device is
configured over SPI.
Figure 16. Initialize Device
4. Choose the desired serialized data format in the
Output Format
control.
5. The default ADC Format is
Analog Input
. This requires no action.
Figure 17. GUI Quick Start Setup: Output Data Configuration
6. At this point, D5 on the TSW1400 EVM should turn on. For the TSW14J56D, D3 turns off, and D4
should start blinking. If this is not the case, please consult the
section. There is most likely
