INB
( J7 )
ADC12DJ5200RF
ADC12DJ5200RF EVM top side
without heat sink installed
INA
( J4 )
USB
Connector
+12V DC
ADC12DJ5200RF EVM top side with
heat sink installed
Power (DC/DC
DQG /'2¶V
)
External device
Clock input ( J10 )
INB+/-
INA+/-
External reference
clock input ( J17 )
FMC+
connector
LMK04828
LMK61E2
ADC12DJ5200RF EVM bottom side
LM95233
Heat Sink for the ADC
Copyright © 2016, Texas Instruments Incorporated
LMX2594
6
SLAU640 – April 2019
Copyright © 2019, Texas Instruments Incorporated
Introduction
Figure 1-1. EVM Orientation
The digital data from the ADC12DJ5200RFEVM board is quickly and easily captured with the
TSW14J57EVM data capture boards.
NOTE:
The TSW14J57EVM cannot be used for JMODES (30 to 39) that use 64b/66b encoding, or
serial rates above 15 Gbps.
The TSW14J57EVM captures the high-speed serial data, decodes the data, stores the data in memory,
and then uploads it to a connected PC through a USB interface for analysis. The High-Speed Data
Converter Pro (HSDC Pro) software on the PC communicates with the hardware and processes the data.
With proper hardware selection in the HSDC Pro software, the TSW14J57 device is automatically
configured to support a wide range of operating speeds of the ADC12DJ5200RFEVM, but the device may
not cover the full operating range of the ADC device. Serial data rates of 15 Gbps down to 1 Gbps are
supported.
