3 SAFETY RULES
The technology used for the design and manufacturing control of the
NAVIGATOR TXT
MULTIHUB
diagnostic tool makes it reliable, simple and safe to use.
The personnel in charge of using the diagnostic tools are required to follow the general safety
rules and to use the
NAVIGATOR TXT MULTIHUB
device for its intended use only and to
carry out the maintenance as described in this manual.
All the requirements based on the following must be assessed and applied:
•
Labour inspectorate.
•
Trade associations.
•
Vehicle manufacturers.
•
Anti-pollution regulations.
3.1 Glossary
Operator:
qualified person responsible for using the diagnostic tool.
Tool:
NAVIGATOR TXT MULTIHUB
The definition of "operator" cannot be applied to minors or to
people with reduced physical, sensory or mental capabilities
or without any experience or knowledge required.
3.2 General Rules
The operator must have carefully read and fully understood all the
information and instructions in the technical documents provided with the
tool.If the operator is not able to read this manual, the operating instructions
and safety indications must be read and discussed in the operator's native
language.
•
The operator that works on vehicles must have basic qualifications and knowledge of
mechanics, automotive engineering, vehicle repairing and of the potential dangers that
may arise during self-diagnosis operations.
•
The operator must be completely clear-headed and sober when using the device; taking
drugs or alcohol before or when operating the tool is strictly forbidden.
•
The operator must follow all the instructions provided in the technical documents.
•
The operator is required to wear adequate personal protective equipment (PPE)
throughout the use of the tool.
•
The operator must monitor the tool during the operating phases wherever this is possible
in compliance with the safety measures indicated below.
•
The operator must periodically check the electrical connections of the tool, making sure
they are in good condition and immediately replacing any damaged cables.
•
The operator must periodically check the parts that are subject to wear and replace them
if necessary, using only original spare parts or spare parts approved by the
manufacturer.
•
The operator must stop using the tool immediately should any failure occur, and promptly
contact the technical assistance.
•
Contact your retailer for extraordinary maintenance operations.
8