13.2 Bluetooth
The Bluetooth connection is the alternative to the Wi-Fi connection for wireless
communication between the VCI and the display unit.
The Bluetooth communication is only possible with display
units with Bluetooth 2.1 or higher.
To configure the communication properly you must use the
serial number indicated on the data plate on the VCI
.
The following screen indicates that the VCI is connected to the display unit in the desired
mode and is awaiting commands.
For further information, see the software operating manual
.
13.3 Network Cable
The communication between the VCI and the display unit through an Ethernet cable
connected to the
DoIP
connector is only possible when the vehicle's compatibility to the ISO
13400 standard is detected.
This communication mode is reserved for use together with
the vehicle manufacturer's proprietary diagnostic software.
Use this type of communication only in particular cases, such
as when reprogramming some control units or if indicated to
by Technical Assistance.
Do not use this type of connection to connect the VCI directly
to a modem, access point or router.
For further information see the DIAGNOSIS chapter.
36
