2. Turn on the display unit.
3. Start the diagnostic software.
4. Launch the VCI configuration function.
5. Follow on screen instructions.
For further information, see the software operating manual.
When turning on the VCI, the first available mode is selected (e.g.: Wi-Fi).
If, during use, the mode in use is no longer available (e.g.: no signal), the connection will
automatically shift to the first available mode (e.g.: Bluetooth).
However, it is always possible to force the communication in the desired mode.
When turning on the VCI, it automatically recognises the communication mode through which
it is connected to the display unit.
The type of communication is indicated on the VCI display.
It is always possible to configure the Bluetooth
communication and Wi-Fi communication in different
moments; however, the two communication modes cannot be
used at the same time.
13.1 Wi-Fi
The Wi-Fi communication between the VCI and the display unit is reserved to
CAN
and
DoIP
diagnostic operations.
For further information see the DIAGNOSIS chapter.
The VCI connects to the display unit in
STATION
mode, i.e. using the workshop's Wi-Fi
network.
For compatibility and radio signal strength reasons, the
workshop's Wi-Fi router must be set to 2.4 GHz.
Connection with a 5 GHz Wi-Fi router is prevented through
software settings of the VCI.
TheVCIcan only connect to the following types of networks:
•
WEP
•
WPA
•
WPA2
34