11.1.2 Battery Cable
The VCI can be powered with a specific wiring to be connected to the battery in the vehicle
being tested via the
PWR
connector.
If the battery is in the rear part of the vehicle, we recommend
connecting the VCI directly to the power supply points coming
from the battery that are available near the area in which you
are operating.
Use the battery power only when specifically requested by the
diagnostic software.
Be careful to respect the polarities indicated on the cables
when connecting to the battery terminals.
Proceed as follows:
1.
Connect the battery cable to the PWR connector.
2.
Connect the cable clamps to the battery terminals.
Incautious operations may expose the operator to the
risk of electric shock, even though of low intensity.
Be very careful when connecting the clamps to the
battery terminals.
In this case the green LED on the cable's
junction box
will also turn on.
27
en