Tetra Pak COMET RC, Руководство пользователя

Страница: 19 / 118

CRC910BE 5-4
Tetra Pak
Hoyer
Fig. 5.6
5.2.5 Ice cream doser/variegator station adjustment
Fig. 5.5
5.2.3 Gauging station adjustment
Fig. 5.4
Adjust doser/distributor height and centre it over
the slot by loosening the screws (Pos. 1/2, Fig. 5.6-
5.6a) to achieve the desired dosing/variegation
position (turning clockwise to increase the stroke of
the pneumatic cylinder or anticlockwise to decrease
it).
Tighten the screws (Pos. 1, Fig. 5.6-5.6a) when
finished.
The end of the dosing nozzles should normally be
inside the container, below the lid position, when
dosing, so that the ice cream decoration will not be
damaged when the lid is pressed on.
The gauging station serves to spread the mouth of
the paper wrapped around the cones, which tends
to fold over during feeding.
5.2.4 Chocolate spray station adjustment
Loosen the screws (Pos. 1/2, Fig. 5.5) to adjust
the height of the spray nozzle and centre it over the
slot, then tighten the screws again when finished.
Loosen the screws (Pos. 1/2, Fig. 5.4) to adjust
height and centring over the slot, then tighten the
screws when finished.
2
1
2
1
3
2
1