Testec TT-AF 1200, Инструкция по эксплуатации

Страница: 5 / 10

3. Description
4. Installation
With high bandwidth, this active 10:1 probe is ideal for timing analysis or troubleshooting of
high speed logic and for design verification of disk drive, as well as for wireless and data
communication design.
a. Simply plug-in the BNC output connector to the vertical input of an oscilloscope
or other measurement instrument with 50Ohm input resistance.
The instrument must have a ground reference.
b. Connect an appropriate power source to this probe or enter the batteries, then turn it on.
c. To use the probe with batteries, first slide open the battery compartment on the rear of
the probe housing and insert the 9V battery
d. You can also use the supplied mains adapter or the optional USB-, PROBUS
or LEMO-power leads.
WARNING To protect against electric shock, use only the
accessories supplied with this probe or the optional
offered TESTEC accessories.
Using the appropriate probe accessories, connect the inputs to the circuits under
measurement.
CAUTION. This probe is to carry out measurement
between two points on the circuit under measurement.
This probe is not for electrically insulating the circuit
under measurement and the measuring instrument.