Test Equipment Depot XFTP SAT LITE, Руководство по эксплуатации

Страница: 19 / 32

19
XFTP SAT LITE Satellite Meter - Operation Manual
Note: The BER and C/N measurements are for reference
only and are only to be used to confirm the quality of your
satellite dish setup.
Press the Direction Button again to display the name of the satellite
and its longitude as shown in the following figure.
If desired, you can press the or Direction Buttons to cycle through
the signal display, measurement mode, and selected satellite information
again.
In the signal display mode, an audible tone may be heard when the signal
level is greater than approximately -67 dBm (-20 dBmV or 40 dB
µ
V) with a
pitch proportional to signal strength to aid in fine tuning the dish position.
Press the
C/S
Button to enable or disable audio.
Align the satellite dish to get the maximum values of signal level and
quality.
When the XFTP SAT LITE is locked onto the satellite signal, the text OK
will appear in the upper right portion of the screen.
Signal Measurements
From the signal display, press the Direction Button to display the
measurements of Bit Error Rate and Carrier-to-Noise ratio as shown in the
following figure.