Tesla S 2017, Руководство пользователя

Страница: 86 / 195

Warning: Auto Lane Change is designed
to be used only when driving on
restricted-access highways (i.e. with on-
ramps and off-ramps).
If your Model S is equipped with Driver
Assistance components (see About Driver
Assistance on page 73), and you have
purchased the optional Enhanced Autopilot or
Full Self-Driving Capability packages, you can
use Auto Lane Change to move Model S into
an adjacent lane without moving the steering
wheel (which would cancel Autosteer). When
both Traffic-Aware Cruise Control and
Autosteer are active, Auto Lane Change
intelligently steers Model S into an adjacent
driving lane. Using the forward looking
camera(s), the radar sensor, and ultrasonic
sensors, Model S detects lane markings and
the presence of other vehicles.
Auto Lane Change is designed for use on
restricted-access highways with visible lane
markings and under relatively predictable
circumstances in which minimal steering and
driver intervention is needed.
Warning: It is the driver's responsibility to
determine whether a lane change is safe
and appropriate. Auto Lane Change
cannot detect oncoming traffic in the
target lane, especially fast moving
vehicles from the rear. Therefore, before
initiating a lane change, always check
blind spots, lane markings, and the
surrounding roadway to confirm it is safe
and appropriate to move into the target
lane.
Warning: Never depend on Auto Lane
Change to determine an appropriate
driving path. Drive attentively by
watching the road and traffic ahead of
you, checking the surrounding area, and
monitoring the instrument panel for
warnings. Always be prepared to take
immediate action.
Warning: Do not use Auto Lane Change
on city streets or on roads where traffic
conditions are constantly changing and
where bicycles and pedestrians are
present.
Warning: The performance of Auto Lane
Change depends on the ability of the
camera(s) to recognize lane markings.
Warning: Do not use Auto Lane Change
on winding roads with sharp curves, on
icy or slippery roads, or when weather
conditions (such as heavy rain, snow, fog,
etc.) may be obstructing the view from
the camera(s) or sensors.
Warning: Failure to follow all warnings
and instructions can result in serious
property damage, injury or death.
Operating Auto Lane Change
Before you can operate Auto Lane Change,
you must enable it by touching Controls >
Settings > Driver Assistance > Auto Lane
Change > ON .
Note: Before you can turn on Auto Lane
Change, you must turn on Autosteer (see
Autosteer on page 82). Without Autosteer,
Auto Lane Change cannot operate.
Note: Your chosen setting is retained until you
manually change it. It is also saved in your
driver profile.
To change lanes using Auto Lane Change:
1. Perform visual checks to make sure it is
safe and appropriate to move into the
target lane.
2. Engage the appropriate turn signal.
3. Disengage the turn signal after you are in
the target lane.
Auto Lane Change moves Model S into the
adjacent lane in the direction indicated by the
turn signal, provided the following conditions
are met:
• The Auto Lane Change setting is turned
on.
• The turn signal is engaged.
• Autosteer is actively steering Model S.
• The ultrasonic sensors do not detect a
vehicle or obstacle up to the center of the
target lane.
• The lane markings indicate that a lane
change is permitted.
• The view of the camera(s) is not
obstructed.
• Lane Assist does not detect a vehicle in
the blind spot (see
Lane Assist on page
92).
• Midway through the lane change, Auto
Lane Change can detect the outside lane
marking of the target lane.
• Driving speed is at least 30 mph
(45 km/h).
Auto Lane Change
Driver Assistance 85