IRSS2010 Steam Iron User Manual
IRSS2010 Steam Iron User Manual
IRSS2010 Steam Iron User Manual
Please follow all the precautions listed below for safety
and to reduce the risk of fire, injury or electrical shock.
Read all the instructions before operating the iron and keep
them for future reference. If you pass the product on to a third
party, include these instructions.
Unplug the iron from the mains supply when not in use,
•
and before emptying, filling, or cleaning.
Do not touch the soleplate of the iron if it is hot.
•
Always hold the appliance by the handle.
•
Keep the appliance well away from surfaces and objects
•
that can be damaged by heat.
Ensure there is adequate room to operate the iron.
•
Ensure that the iron cannot fall into water.
•
Do not immerse the connecting cord in any liquid.
•
Do not let the connecting cord overhang the edge of the
•
work surface or allow it to touch hot surfaces or sources
of heat or flame.
When unplugging the power cord, hold the plug top, not
•
the power cord.
If any part of this appliance is damaged or malfunctions
•
in any way, or the connecting cord or mains plug is broken
do not continue to use it. Seek expert assistance.
Do not use the iron if water is leaking from it.
•
Parents must warn children not to touch hot appliance
•
parts. Close supervision is necessary when an appliance
is used near children.
Small children should not use this appliance.
•
Do not leave the iron face down at any time. Stand it
•
upright on its heel, on a level heatproof surface.
Do not use outdoors or in damp or wet conditions.
•
When placing the iron on its stand, ensure that the
•
surface on which the stand is placed is stable.
Do not use this iron for professional laundry services.
•
Do NOT use this appliance for any purpose not covered
•
by the instructions.
Use caution when turning the iron upside down, there
•
may be hot water in the water tank.
Never wind the mains lead around the iron, coil it loosely
•
for storage.
Use only with a purpose-built ironing board.
•
Observe all ironing instructions and ironing temperature
•
dot settings given by the garment manufacturer. These
are normally on a label or labels inside the garment.
This appliance is not intended for use by persons
•
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of this appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
•
play with the appliance
THE IRON MUST NOT BE LEFT UNATTENDED WHILE IT IS
CONNECTED TO THE SUPPLY MAINS.
DO NOT USE THIS IRON IF IT IS DROPPED, HAS VISIBLE SIGNS OF
DAMAGE OR IS NOT WATERTIGHT.
ELECTRICAL INFORMATION
Before using this appliance ensure that the voltage of
your electricity supply is the same as that indicated on the
appliance.
The means of disconnecting this appliance from the mains
supply is the mains plug. This should be unobstructed and
readily operable at all times
This appliance must be earthed.
SPECIFICATIONS
Voltage Rating: ....................220 -240 V~, 50 Hz
Power Consumption: ............1650 - 2000 W
Net Weight: ..........................1280 g
BURNS CAN OCCUR FROM TOUCHING HOT METAL PARTS, HOT
WATER OR STEAM. EXERCISE CARE WHEN HANDLING THIS
APPLIANCE!
USING THE IRON
Ironing Temperatures:
Check the ironing instructions attached to the article (they are
on a label showing a symbol of an iron). Always follow these
ironing instructions. The indications on the iron’s temperature
dial and the table below will help you.
If there are no ironing instructions but you know the fabric,
then use the table below. The table is valid only for the actual
materials and does not take account of any finish applied
to the fabric. Textiles to which a finish has been applied
(wrinkle relief, printed T shirts etc.) should be ironed at lower
temperatures.
If the fabric contains mixed fibres, select the lowest ironing
temperature of the composition, e.g. iron a 60% polyester
/40% cotton mix at the temperature indicated for polyester.
Do not iron
Synthetics. Set Iron to LOW ( • )
Wool, Silk. Set Iron to MEDIUM ( • • )
Cotton, Linen. Set Iron to HIGH ( • • • )
The iron heats up quicker than it cools down. Sort fabrics to be
ironed into groups according to temperature; wool with wool,
cotton with cotton, etc. Start by ironing articles requiring low
temperature settings and progress to higher ones.
Note: Do not iron garments that are dirty or stained. The iron’s
heat may set the stain.
Pure (100%) wool fabrics may be pressed with the iron set to a
steam position and the garment protected by a dry cloth.
Using the Iron:
Before using the iron:
Inspect the iron carefully. Check that the voltage marked on
the rating plate matches your mains voltage.
Remove any protective film from the soleplate. Polish the
soleplate lightly with a clean soft cloth to remove any
residues.
Important Note: Maintaining the finish of the iron’s soleplate
is essential. Keep the soleplate smooth: do not scratch it on
metal objects (e.g. the edge of the ironing board, buttons,
zippers, etc.) as these may impair performance.
Preliminaries
Unpack the iron carefully. If you dispose of the packaging, do
so having regard to any recycling regulations in your area.
The packaging contains:
One Tesco iron
•
One filler cup
•
If any item is missing or damaged please contact the Tesco
store where you purchased the item, or your nearest Tesco
store. Please have your receipt ready when you call.
Filling the Iron:
DO NOT use water containing softeners, perfumes or
additives as these may damage the iron irreparably.
Unplug the iron from the mains.
•
Set the Steam control to OFF.
•
Open the water filler. Fill carefully with fresh water using
•
the supplied filler cup. Do not fill the iron above the MAX
mark indicated on the side of the iron.
Important Special Features of Your Iron
Anti-Drip system:
This is designed to prevent water escaping
from the soleplate when the iron is cold. During use, the anti
drip system may emit a loud clicking sound, particularly when
heating up or cooling down. This is perfectly normal and
indicates that the system is functioning correctly.
Anti-Scale system:
The built-in anti-scale cartridge is designed
to reduce the build-up of lime scale which occurs during steam
ironing and will prolong the working life of your iron. The anti-
scale cartridge will not completely stop the natural process of
lime scale build-up so always empty the water after use and
self-clean the iron regularly (see last page).
MAIN COMPONENTS
Spray nozzle
1.
Water filler & cap
2.
Steam control
3.
Spray button
4.
Shot of steam button
5.
Temperature indicator
6.
Temperature dial
7.
Handle
8.
Power indicator
9.
Mains lead
10.
Soleplate
11.
Maximum fill line
12.
If you live in a hard water area, it is advisable to use distilled or
de-mineralised water.
Operation:
Ensure the mains socket is switched off at the wall and
•
the Steam Control is OFF (see previous page).
Fill the iron with water as described above.
•
Place the iron on its heel on the ironing board rest and
•
connect the power cord to the wall socket.
Switch on the power. The pilot light will illuminate.
•
Select the correct temperature. Turn clockwise to
•
increase and anticlockwise to reduce temperature.
IRSS2010 V0.3
