Quickstart document
18
The probe will have to be moved manually by the user in order to detect the reference mark.
Once the mark is found, the instruments beeps and the software enters in ST1/ST2 mode or
displays the main menu (user selection in system options).
5.4 Main menu
Once the initialisation process has been performed, the software will display by default its
main menu.
Four main modes are displayed on this page.
Mode Description
ST1
Allows quick measurements in one probing direction, without
the need to calibrate the probe prior to it.
The probing direction must be identical as the one used to
define the current reference.
ST2
Allows quick measurements in two probing directions
Probe calibration is mandatory before any access to the mode
Perpendicularity
To measure using an accessory as IG13 probe and define
perpendicularity or straightness errors.
Calculator
Allows to proceed to the following calculations:
With values inserted manually
With values previously measured
To save a customised function that takes (or not) into account
the results measured previously.
5.5 Measurement
mode
