87
/
167
Replace the drive harness
Replace the Autopilot (Controller)
Contact the distributor or FAE department of manufacturer.
5.4
Set up the Equipment
AG960 is set up by 5 steps as following.
System setting. To set the model of main components and assemblies of the
autopilot
Host setting. To set the installation position and orientation of the Autopilot
(Controller) on the agriculture machine
Antenna setting. To set the installation position and orientation of the satellite
navigation antenna
Vehicle setting. To set the dimensional parameters of the vehicle
Implement setting. To set the dimensional parameters, connecting positions,
operation width parameters of implements.
In addition, the autopilot program needs to be updated in some special cases; details
of program updating process will also be given in this section.
5.4.1
System Setting
Touch “Setting” icon
in the main menu zone at the left side of the screen to
enter the setting screen, as shown in the figure below. The setting screen further has 6
sub-screen from left to right, namely “System setting” (Default sub-screen after
entering the setting screen), “Host setting”, “Antenna setting”, “Vehicle setting”,
“Implement setting” and “Program updating”. Touch corresponding icon at the top
of the screen to enter each sub-screen. There is a “Back” button at the left upper
corner of the screen. Touch this icon to exit from the setting screen and enter the main
interface of the panel computer.