29
/
167
4.1.2.3
Route RF Cable of Radio Receiving Antenna
After the radio receiving antenna is installed, route the RF cable. The pedestal of radio
receiving antenna is provided with RF cable. Route the cable along the driving cab
top and fix it with cable tie holder with double faced adhesive tape. It is recommended
to bind the RF cable of radio receiving antenna together with two 3M RF cables of
satellite navigation antenna and hang them from the rear side of the vehicle as a whole
so as to enter into the driving cab through the rear side or rear window. In this way,
the cable routing is neat and tidy.
Figure 33 Fix and bind the RF cables on the driving cab top and lead them into the driving cab
from the rear side window
4.1.3
Installation of Panel Computer
The panel computer is the user operation interface of AG960 and it is installed onto
the vehicle according to the following procedures.
4.1.3.1
Installation Position of Panel Computer
The panel computer must be installed inside the driving cab to avoid rain. Considering
that usually the driver operates with right hand and gets on or off the vehicle from the
left side of the driving cab, it is recommended to install the panel computer to the
right side or right front position (consult the driver before installation). The screen of
the panel computer should have a proper distance from and a proper installation angle
for the driver to facilitate driver’s operation.
