127
/
167
5.5.6.4
Calibration of System Deviation – Step 4
The screen below shows that the calibration is done.
Figure 166 The calibration is done
When the calibration is done, the screen will display the calibration results. Observe
the calibrated results, which should satisfy the following requirements.
Calibrated path deviation:
≤
3
°
Fine calibrated guide wheel deviation:
≤
3
°
When both the requirements are satisfied, the calibration of system deviation is
correctly done.
When the calibration of “System deviation” is done, perform the calibration again by
selecting “Iterative calibration” to make sure that the system deviation is completely
eliminated.
When the calibration of system deviation is done, enter “Calibration” button again
and it will be expected to see that the icon of system deviation calibration turns green.
