109
/
167
screen. Touch the “attitude calibration” button
in the calibration screen and
the sub-screen as shown in the figure below pops out in the screen.
Figure 144 Sub-screen “Attitude calibration” pops out
The attitude calibration process can be completed by following the instructions in
sub-screen “Attitude calibration”.
5.5.3.1
Attitude Calibration – Step 1
Drive the tractor to a flat ground and keep idling of engine. Now put a stone or branch
as a mark at the outer edge of the rear wheel of the tractor or make a mark with a
chalk on the ground at the outer edge of the rear wheel.
Touch “Next step” button to proceed with step 2.
