Safety instructions
Please observe the following strictly:
● Always replace the light source when the mains power cord is unplugged.
● The lamp fixture contains no user-serviceable parts. Never disassemble the lamp fixture! Repairs
may only be carried out by qualified personnel!
● Do not look directly into the light of the lamps!
● Do not use a light source with a higher output than allowed!
● The controller is for indoor use only, it should not be used under water, in wet rooms and at high
humidity!
● Do not use for aquariums!
● Do not use the lamp fixture near flammable materials!
● Do not remove the bottom cover of the lamp fixture!
● If the lamp fixture is damaged, stop using it! Damaged lamp fixture must be replaced
immediately.
● Handle the lamp fixture carefully and always use it as intended! Protect it bumps, shocks, falls
because they may be injured or will not function properly!
● Cleaning must be carried out with the mains power cord disconnected. Do not use harsh
chemicals for cleaning! Clean it gently with a slightly damp cloth.
● When servicing or maintenance in a terrarium, be sure to disconnect the mains power of the lamp
fixture!
● Do not use the lamp fixture through glass due to the effect loss of light and heat! Access to the
light and heat source toward the terrarium shall be provided, eg. through metal mesh or densely
perforated metal sheet!
● Do not use the lamp fixture for plastic mesh terrariums os flexariums as the heat generated by
lighting and heating source can cause a fire!
● When designing the terrarium, make sure that the animal does not touch the lamp fixture. The
use of metal mesh or densely perforated metal sheet is recommended.
● Do not cover the lamp fixture!
● It warms up during use. Do not touch immediately during operation or after power off!
● Immediately remove a faulty or malfunctioning light or heat source from the lamp fixture.
● If any part of the lamp fixture gets wet, disconnect it immediately!
● Make sure that the light or heat source of the lamp fixture is not focused on any plastic object in
the terrarium!
Use in harsh conditions is not allowed. In such circumstances:
● water directed at it (dripping or splashing),
● air humidity too high (> 95 %),
● ambient temperature too high (> 40 °C),
● presence of large amounts of dust and flammable gases, vapors and solvents,
● input voltage outside the range of 220...240 V,
3/12
Document number:
TC-HUJJ-2020/01-EN v3.2
