TerraKing TKV 20, Руководство оператора

Страница: 9 / 20

9
Assembly
Connecting the PTO Shaft
1.
Flip up the shield (A). With square key (B) in keyway
of the shaft, slide the PTO shaft onto the TKV 20 and
tighten the setscrew (C) to 28 +/-2 ft. lbs.
2.
Connect the PTO shaft to the tractor’s PTO and
ensure lock pin (D) is engaged.
3.
Lift the tractor’s 3-point arms up and down to ensure
that the PTO telescopes freely. Ensure that the PTO
shaft does not come apart when the 3-point arms are
at their highest point.
Blower Inlet Hose
1.
Position mower deck in lowest mowing position.
2.
Slide hose on front of blower as far as possible. Lay
other end beside the boot. Lift and lower the 3-point
arms to observe the distance between the boot and
the blower inlet. Cut the hose long enough to fit in all
positions. The plastic can be cut with a utility knife,
but the wire requires wire cutters or a saw.
3.
Slide clamp over hose and hose onto blower inlet.
Close the latch (A) to clamp. If clamp is too loose,
tighten the screw (B). To prevent stripping the screw,
unlatch before tightening.
4.
Repeat step #3 on boot end.
5.
Lift the tractor's 3-point arms up and down to ensure
that the blower hose moves freely.
6.
Ensure that the blower hose does not contact
the ground during operation as this could cause
excessive wear or damage.
B
A
D
C B A