Termozeta Tagliacapelli 5000, Инструкция по эксплуатации

Страница: 14 / 16

ENGLISH
After each cut the blades should be cleaned of any accumulated hairs and
lubricated to keep the appliance in good working order.
Proceed as follows:
• ensure that the switch is in the “0” (appliance off) position;
• extract the guide comb by sliding it upwards to its
full extent and removing it from its position;
• remove any accumulated hair using the brush
supplied (10) as shown in fig. 1;
• pour one or two drops of oil (11) onto the blades
as shown in fig. 2;
• run the appliance for a few seconds to let the oil
spread over the entire surface of the blades;
• switch off the appliance and remove any excess oil
with absorbent paper;
• wash the guide comb with water and a mild
detergent, dry thoroughly and reinsert into the
appliance making sure the side tabs are slotted
into place correctly.
IMpORTAnT!
Use only the oil supplied to lubricate the blades.
Do not use edible oil, cosmetic hair oil, oil mixed with other substances such as kerosene
or other solvents which could permanently damage the blades and appliance.
The appliance body and the recharging stand (6) may be cleaned with a soft, slightly
damp cloth; always disconnect the charging adapter from the mains before cleaning.
CAUTIOn!
Do not use chemical or abrasive products.
Never immerse the appliance, the charging stand or the charging adapter in
water or other liquids.
At the end of the life cycle of the appliance, it is essential to remove the internal batteries
and dispose of them separately c/o the proper collection centres.
To remove the internal batteries, please follow the procedure below:
• Switch on the appliance until it runs out
• Push the blades outwards and remove the whole blade group of the appliance (fig. 3)
• Remove the three screws on rear appliance body(see fig. 4)
• Separate the two parts of the appliance body (fig. 5)
• Cut the two electrical connections and remove the batteries
CLEANING AND MAINTENANCE
REMOvAL OF INTERNAL bATTERIES
Fig.1
Fig.2