XM-RVR-FM-001
Installation Guide
Important!
• This XM Receiver is designed to be use in automobiles with 12V battery and negative grounding. Before installing
in any vehicle, ensure that the battery voltage is proper.
• Before installing this system, be sure to disconnect the “negative” battery cable to avoid short circuits.
• Refer to the vehicle’s Owner’s Manual for details on connecting power amplifiers and other units before
proceeding to make connections.
• Secure all wiring with appropriate clamps and/or adhesive electrical tape. To protect wires, wrap adhesive
electrical tape around them where they contact any surface.
• Route and secure all wiring so it is free and clear of all moving parts such as gear shifts, pedals, hand brake and
seat rails. Keep all wiring free and clear of any areas prone to excessive heat. Damaged wiring (ruptured insulation)
can cause a short circuit if it contacts the vehicle body.
•
DO NOT
pass the yellow lead through a hole in the engine compartment to connect to the battery as this can
cause damage to the wiring and insulation and create the potential for a dangerous short circuit.
•
DO NOT
shorten any leads. Shortening leads may prevent the proper functioning of the protection circuit.
• Never feed power to other units by stripping the insulation of the power supply lead and tapping into it with
another unit’s lead. This will exceed the units current capacity and cause the unit to overheat.
• If replacing a fuse, be sure to use only the fuse specified inside the fuse holder.
• If this unit is installed in a vehicle that does not have an Accessory (ACC) position on the ignition switch, the red
lead of the unit should be connected to a terminal coupled with ignition switch “On/Off” operations. Failure to do
so will cause the unit to drain battery power if left unattended for an extended period.
!WARNING:
Professional Installation Recommended. Failure to properly follow all installation instructions may
result in personal injury or damage to your XMCOMMANDER, your vehicle or your vehicle A/V system.
ACC position
No ACC position
Distributed by
Controller/Display Installation
Notes:
• Be sure to keep controller out of direct sunlight and/or excessive heat for prolonged periods as damage may occur.
• Locate the unit in an area of the vehicle where it will not obstruct the driver’s operation of the vehicle and where it
will not pose a risk to driver or passenger in the event of an emergency stop.
• When Mounting the Controller/Display, ensure that all wires and cables are free of crimps and kinks and are not
trapped between the unit and the mounting surface.
• If your vehicle dashboard has an appropriate, available opening the enclosed mounting cradle can be used to
provide a flush, seamless positioning.
