Terex Genie Z-60 DC, Руководство по обслуживанию и ремонту

Страница: 12 / 125

Service and Repair Manual December 2018
Specifications
2 Z®-60/37 DC • Z®-60 /37 FE Part No. 1271125GT
Performance Specifications
Drive speed, maximum
stowed position
2WD/4WD models Stowed 4.0 mph
6.44 km/h
40 ft / 6.8 sec
12.2 m / 6.8 sec
Elevated 0.7 mph
1.0 km/h
40 ft / 40 sec
12.2 m / 40 sec
Gradeability See Operator's Manual
Braking distance
High range on paved surface 3 to 6 feet
0.9 to 1.8 m
Function speeds, maximum from platform controls
Jib boom up 13 to 17 seconds
Jib boom down 13 to 17 seconds
Primary boom up 54 to 66 seconds
Primary boom down 54 to 66 seconds
Primary boom extend 40 to 50 seconds
Primary boom retract 31 to 39 seconds
Secondary boom up 31 to 39 seconds
Secondary boom down 31 to 39 seconds
Turntable rotate, per 90°
Stowed 21 to 27 seconds
Turntable rotate, per 90°
Not stowed 35 to 42 seconds
For operational specifications, refer to the
Operator's Manual.
Hydraulic Oil Specifications
Hydraulic Fluid Specifications
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation prevention, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
Cleanliness level,
minimum ISO 15/13
Water content,
maximum 250 ppm
Recommended Hydraulic Fluid
Hydraulic oil type Chevron Rando HD Premium
Viscosity grade 32
Viscosity index 200
Optional Hydraulic Fluids
Mineral based Shell Tellus S2 V 32
Shell Tellus S2 V 46
Shell Tellus S4 VX 32 Shell
Shell Donax TG (Dexron III)
Chevron 5606A
Biodegradable Petro Canada Environ MV 46
Fire resistant UCON Hydrolube HP-5046
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult Genie Product
Support before use.
Optional fluids may not have the
same hydraulic lifespan and
may result in component
damage.
Note: Extended machine operation can cause the
hydraulic fluid temperature to increase beyond it's
maximum allowable range. If the hydraulic fluid
temperature consistently exceeds 200°F / 90°C an
optional oil cooler may be required.