Section 3 • Scheduled Maintenance Procedures
August 2016
Part No. 218567
AL4 • AL4000
3 - 9
A-8
Check the Tires and Wheels
Axle specifi cations require that this procedure be
performed weekly.
Maintaining the tires and wheels in good
condition and the tires at the correct pressure is
essential to safe operation and good performance.
Tire and/or wheel failure could result in a machine
tip-over. Component damage may also result if
problems are not discovered and repaired in a
timely fashion.
Bodily injury hazard. An over
infl ated tire can explode and could
result in death or serious injury.
Tip over hazard. Do not use
temporary fl at tire repair products.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracks.
3 Check pressure in each tire. Add air as
necessary to meet specifi cations.
Specifi cation
Air pressure
50 psi
3.4
bar
A-9
Inspect the Engine Air Filter
Genie specifi cations require that this procedure
be performed every 40 hours or weekly, whichever
comes fi rst.
Maintaining the engine air fi lter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
1 Open the engine compartment.
2 Remove the air fi lter element.
3 Clean the inside of the air fi lter canister and the
canister gasket with a damp cloth.
4 Inspect for and remove any blockage or debris
from the intake air passages.
5 Inspect the air fi lter element. If needed, blow
from the inside out using low pressure dry
compressed air, or carefully tap out dust.
6 Securely install the fi lter element into the
canister.
7 Install the gasket and baffl e (if equipped), and
end cap onto the air cleaner canister.
Note: Be sure the dust discharge valve is facing
down when installed.
8 Secure the end cap to the air cleaner cannister
with the retaining clamps.
CHECKLIST A PROCEDURES
Discount-Equipment.com
