Teracom TCW181B-CM, Руководство пользователя

Страница: 2 / 13

TCW181B-CM_R1 Page 2
3. Technical parameters
Supply voltage, VDC 12 ± 2
Maximum current ( with all relays ON), mA 370
Weight, g 205
Dimensions, mm 115 x 90 x 40
Operating temperature, °C 0 to +40
Maximum humidity in 0 to 31°C range, %RH 80
Maximum humidity at 40°C (linear slope between 31-40°C), %RH 50
Minimum high level input voltage for digital inputs, VDC +2.5
Maximum low level input voltage for digital inputs, VDC +0.8
Maximum input voltage for digital inputs, VDC +5.5
Maximum switchable current for relay contacts, А 3
Maximum switchable voltage for relay contacts, VAC/VDC 30/24
4.
Connectors
The location of the connectors and LED’s are shown below:
Connector 1
Pin 1/2/3 - NO/COM/NC of Relay5
Pin 4/5/6 - NO/COM/NC of Relay6
Pin 7/8/9 - NO/COM/NC of Relay7
Pin 10/11/12 - NO/COM/NC of Relay8
Connector 2
Pin 1/2/3 - NC/COM/NO of Relay4
Pin 4/5/6 - NC/COM/NO of Relay3
Pin 7/8/9 - NC/COM/NO of Relay2
Pin 10/11/12 - NC/COM/NO of Relay1
Connector 3
Pin 1 - Digital input ( DI )*
Pin 2 - Ground
Pin 3 - +12VDC
Connector 4 -
Power, Ø2mm, central positive
Connector 5 - Ethernet – RJ45
* O
perating mode is selected by jumper DI on PCB - closed for “dry contact” and open for
“logic level”. By default jumper is closed.
5. LED indicators
The following indicators show the status of the controller:

Relay 1 to 8 status (green) - turns ON when the corresponding relay is activated;

Sts (red) – flashes when the main program of controller is executed;

Log (yellow) – turns ON when someone is logged to the controller via WEB interface;

Link (green) – located on the Ethernet connector, turns ON when the device is
connected to the LAN;

Act (yellow) – located on the Ethernet connector, flashes when activity on the LAN is
detected.