TCG120 _R1.1 - March 2015
Page 4
6. Installation
This device must be installed by qualified personnel. Installation consists of mounting the device,
connecting to the GSM network, connecting inputs and outputs, providing power and configuring via a
web browser. This device must not be installed directly outdoors.
Attention! Before installing the SIM card in the card slot, please ensure that the PIN code is
disabled.
6.1. Mounting
TCG120
should be mounted in a clean and dry location on not flammable surface. Ventilation is
recommended for installations where ambient air temperature is expected to be high.
Mount the device to a wall by using two plastic dowels 8x60mm (example Würth GmbH 0912
802 002) and two dowel screws 6x70mm (example Würth GmbH 0157 06 70). Attach the screws to the
surface vertically. See Appendix-A, fig. 1 for mechanical details.
Maintain spacing from adjacent equipment. Allow 50 mm of space on all sides, as shown on fig.2 in
Appendix A, this provides ventilation and electrical isolation.
6.2. Connectors
Attention! Disconnect power supply before wiring.
The correct wiring procedure is as follows:
Make sure power is turned off;
Make wiring connections to the terminals;
Apply power.
It is recommended to test and configure
TCG120
without any controlled device
Make sure that wires are properly attached to the terminals and that the terminals are tighten. Not
proper wiring and configuration can cause permanent damage of
TCG120
or the equipment to which it
is connected or both. Inputs and outputs locations are shown below:
Connector 1
– Power - central positive
Connector 2, Pin1 -
Digital input 1 (
Din1
)*
Connector 2, Pin2 -
Digital input 2 (
Din2
)*
Connector 2, Pin3 -
Ground
Connector 2, Pin4 -
Analog input 1 (
Ain1
)
Connector 2, Pin5 -
Analog input 2 (
Ain2
)
Connector 2, Pin6 -
Ground
Connector 2, Pin7 –
1-Wire data
Connector 2, Pin8 –
1-Wire power supply
Connector 3
– mini USB
Connector 4 –
SIM card holder
Connector 5 –
GSM Antenna
Connector 6, Pin1
– NC Relay1
Connector 6, Pin2
– COM Relay1
Connector 6, Pin3
– NO Relay1
Connector 7, Pin1
– NC Relay2
Connector 7, Pin1
– COM Relay2
Connector 7, Pin1 –
NO Relay2
* Operating mode is selected by jumper DI1/DI2 - closed for “dry contact” and open for “logic
level”. By default jumpers are closed.
Содержание TCG120
Страница 1: ......
